Minimum diameter and maximum spacing steel mesh reinforced concrete pavement on the application of reinforced concrete pavement with steel mesh should be consistent with current industry standards JTG D40 provisions "of cement concrete pavement design specifications." When using cold-rolled ribbed steel mesh sheet, bar diameter not less than 8mm, longitudinal reinforcement spacing should not exceed 200mm steel mesh properties, transverse reinforcement spacing should not exceed 300mm. The vertical and horizontal steel mesh reinforcement should adopt the same diameter, reinforced protective layer thickness of not less than 50mm. Reinforced concrete pavement reinforcing steel mesh reinforced concrete pavement can be used to perform with the relevant provisions of the steel mesh. When a concrete pavement structure with fixed convergence of expansion joints can not set the dowel can be configured in a double-layer steel mesh structures adjacent to the plate ends; or within a length of about 6 to 10 times the thickness range The thickness is gradually increased by 20%. 2, concrete pavement and bridge phase, the bridge has a slab should be set 6-10mm long reinforced concrete surface layer mesh panels at the transition between the slab and the concrete surface laminates. When the bridge is oblique, acute part of the reinforced concrete slab steel mesh reinforcement should be used. Under 3, the surface layer of concrete structures laterally across the box, the distance from the top surface to the bottom surface of the surface layer is less than 400mm or embedded steel mesh when the grass in the top width and structures on both sides of the concrete surface layer should be laid double reinforced mesh, steel mesh on the lower surface of each layer from the top and bottom 1/4 - 1/3 the thickness of the place. Under the surface layer of concrete structures with round tubular steel mesh wholesale laterally across its surface layer from the top surface to the bottom surface is less than 1200mm, both sides in the structure, the concrete surface should be laid single steel mesh, steel mesh located in the surface layer from the top surface 1/4 - 1/3 the thickness of the place. Taken industry standard "of cement concrete pavement design specification" JTG D40-2002. Cold-rolled ribbed steel mesh are export-oriented architecture ribbed steel mesh. ф5-10mm cold-rolled ribbed steel wire rod, straight, same or different diameters of longitudinal reinforcement and transverse reinforcement spacing requirements respectively vertically, all cross points are used for resistance spot welding together steel mesh. Cold-rolled ribbed steel mesh steel mesh steel-degree specification, good elasticity, spacing evenly accurate, high weld strength, thus greatly improving the quality of construction. Welded steel vertical bars and horizontal bars form a mesh structure, bonding with the concrete anchor is good, bear the load evenly spread distribution, significantly improve the seismic performance of reinforced concrete structures crack. Mainly used in the construction of floors, walls, floors, deck installation of tunnel lining, aspects of water conservancy facilities, prefabricated pipes, foundation piles. Steel mesh | Lei Wang steel mesh | wholesale steel mesh network provided by Ray Wang Netherlands. Lei Wang Anping Wire Mesh Products Co., Ltd. (www.apleiwang.com/) network in the Netherlands, wave nets, dip nets Netherlands, construction mesh industry has high visibility, integrity management, both quality of service, welcome to inquire , or consult our "Business League call" it!