Lei Wang Anping Wire Mesh Products Co., Ltd. (http://www.apleiwang.com/) is located in Hengshui Anping Taiwan City Development Zone Contact: Zhu Lei Helan dip net fence technology is based on high-quality steel corrosion is basically, the different colors of the plastic melt has rust steel wall in the name of a high strength, strong adhesion, good corrosion resistance, long life outdoors, wide scope to other characteristics of the product a practical temperature of 190 ℃ 220 ℃ dip Plastic products suitable, there is the appearance of the product surface gloss plump like a porcelain-like, delicate touch, no infection, no bubbles, no blisters, no cracks, and high strength, impact Dutch network technology, anti-aging, strong adhesion, the overall corrosion, wear tube exclusive mining technology, no welding, weld, products with seamless, never fade, rust and other strengths. Dutch network dip in foreign fence preservative technology has been widely used, while domestic but just beginning. Another Dutch network Dip fence compression wear, and steel guitar Third strong, negative resistance value is high, does not occur static, non-porous coating as a whole, the most up to 5mm thick film once, long life, partially damaged repairable adapt outdoor minus 70 ℃ to 90 ℃ temperature, aging more than 20 years of weathering, and steel joint force of up to 6mpa; minimum of 2.2 mpa; tensile strength of not less than 9.7mpa; compressive strength 21mpa; and can pick any color , never fade. Dutch network Dip fence change the traditional product in the outdoor sun and wind and other harsh environment that is prone to short-term anti-corrosion layer peeling, cracking, and then lead to loss of corrosion consequences, greatly affected the life, and the emergence of the Dutch network Dip fence , a change in the original Dutch network of various bad scene, not only in outdoor high levels of anti-aging, and the process by dip fence products made out of thick anti-corrosion coating, electrostatic spray coating up to the traditional process several times over ( Individual thickness 0.5mm--1mm) in a particular case can be thicker in the case of outdoor Stock Dutch network protection scope deformities corrosion life of more than two decades. Dutch network during welding may occur the problem 1, welding temperature changes, cracks cracks reason is welded directly heightening the temperature to a high temperature, in order to reduce the occurrence of this situation, on the one hand We can weld preheating, good crack resistance on the other hand you can use low-hydrogen electrodes and so on. 2, the Dutch network of welded joints is not defended by the interface through which is due to dirty welding, welding method of operation is not correct. Before welding welding mouth we want to clean up first Dutch network specifications, keep dry, to use the correct welding method. 3, did not appear at the interface fusion welding or soldering interface does not appear fusion pores may be due to use of unsuitable or welding electrode surface is not clean, because the weld porosity occurs when a bubble bath in the weld solidification failed escape and left to form the hole. Dutch network in the welding process to avoid these situations, we must first prepare a suitable electrode, we must advance the welding mouth clean, using the correct welding methods.